Sadolin PV67 Heavy Duty Varnish

For optimum results, always do a test area before starting any project to assess product suitability and final finish. Warm and dry conditions assist with proper drying / curing, whilst excessive humidity or low temperature will affect the chemical reaction in the overall finish. Good air flow and ventilation are essential at ground level during and after application.

To begin application, ensure the product is thoroughly stirred before and during application, otherwise sheen and colour variations may be experienced. Sadolin PV67 Heavy Duty Varnish is mixed in the ratio of 10 parts varnish to 1 part hardener, by volume. Apply Sadolin PV67 in full flowing coats, ensuring wooden bar tops and other surfaces are fully coated with the lacquer, and for best results, use a soft, natural bristle brush, lambs wool applicator or quality woven short to medium pile roller. Finish with 3 full coats of Sadolin varnish allowing a minimum of 3-4 hours drying between coats.

Carefully denib the fist coat using a fine grade nylon abrasive pad or a fine grade wet or dry silicone carbide abrasive paper in the direction of the grain before over-coating. Do not break through the surface coating and remove all sanding dust.

All subsequent coatings should be applied as soon as possible after the previous coat has fully cured.